There are various flooring products available today. From wood, vinyl, laminate, and other options, the carpet still is commonly used by all.
The carpets add a unique touch to a house's interior. Not only it looks elegant, but also brings warmth and softness to the house. Besides that, the carpet also requires a very minimal amount of maintenance and cleaning, unlike the expensive solutions in the hard surfaces.
However, on the other hand, the carpets hang on the stains for longer than hard flooring. Thus, to remove these in comparison to the hard surfaces- it is difficult. Hence, there are some tips and tricks one can use to remove stains and spills. Now, you can keep your carpets clean without worrying about the damage!
How to clean the carpets?
One must always bear in mind, not to rub the stains immediately. As when you start scrubbing the fresh stain, it will only cause the spot to spread around and get deeper into the carpet.
So, what can you do?
It is simple, instead of wiping it off, dab the stain with a cleaning element. Use a clean piece of cloth, sponge, or a paper towel and soak in the cleaning solution before tapping the stain. It is also known as, blotting. Blotting means; putting pressure on the stain to soak it up. However, one must remember never to start blotting from the inside to the outside- as it spreads further. Therefore, one should always start the dab from the outside to the inside.
You can contact carpet steam cleaning in Ballarat services to help you out. Steam cleaning is when the machine extracts the dirt and trash from the carpet along with the cleaning solution. It is the most affordable and convenient way of keeping the carpets look brand new.
Wine spills are the hardest to get rid of from the carpets. But you might have heard of the club soda technique- if done correctly, it is the most effective way of removing the beer stains.
How to use the club soda?
Use a clean cloth soaked in club soda to blot the spot. If the stain gets lighter; use more soda to make the stain disappear.
However, if this method doesn't work, use white vinegar and water in a one-to-one ratio. Then use this solvent to spray on the stain and let it get soaked for ten to fifteen minutes. Once it is completely soaked up, use a dry sponge or a piece of cloth to put pressure on that region. Hence, doing this will absorb the cleaning element as well as reduce the stain. One must repeat this process until there is no mark left.
After the mark is gone, rinse the area using warm water. After that, one should place a dry towel on the wet region and keep it for a few hours under pressure. By doing this process, the towel will consume all the dampness and leave your carpet stainless.